EcoPure MW_MW40_450216 - Manual (Page 10)

..................................................AUTOMATIC WATER SOFTENER
PROGRAMMING THE MW-40 DEMAND TIMER
" TIMER SETTINGS REQUIRED...upon installation, and after an extended power outage (see Program Memory,
page 19).
NOTES:
# WHEN THE TRANSFORMER IS PLUGGED INTO THE ELECTRICAL OUTLET (STEP 10, ABOVE), 12:00AM
(flashing), and PRESENT TIME show in the upper display area. Program the timer as follows. If A- - - is flashing,
please see Model Code setting on page 20.
# A ‘‘beeper’’ sounds while pressing buttons for timer programming. One beep signals a change in the timer display.
Repeated beeps means the timer will not accept a change from the button or arrow you have pressed, and you
should use another.
# To program the timer, you will use the either SET, UP or DOWN buttons.
! SET PRESENT TIME OF DAY....................................................................................................
NOTE: If the words PRESENT TIME do not show in the display, press the SET button until they do.
1. Press the SET, UP or DOWN button to set. The UP
button moves the display ahead; the DOWN button
moves the time backward.
NOTE: Each press of the UP or DOWN button arrow
changes the time by one minute. Holding the buttons
in changes the time 32 minutes each second.
2. When the present time shows, press SET to apply.
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure AM
shows.
MW-40
MW-40
10