EcoPure ECOP30 - Manual (Page 12)

12
Step C: Install RO Filter Assembly
INSTALL REVERSE OSMOSIS FILTER
ASSEMBLY
The Reverse Osmosis Filter Assembly is mounted on
hanger washers.
See Fig 13. The hanger washers allow you to lift the fil-
ter assembly from the washers without any hardware
removal. When planning your installation, you need to
leave room for changing filters.
Complete the following steps to install your Reverse
Osmosis Filter Assembly:
1. Remove the cover.
2. Locate mounting slots on back inside of the assem-
bly. See Fig 13.
3. Hold the assembly up to the wall surface and mark
locations for the hanger washers. See Fig 13. Mount
the unit high enough to allow room to change filters
without taking the unit off of the wall.
4. Fasten the hanger washers to the wall using the
screws provided.
5. Hang assembly on washers.
6. Replace cover.
9''
FIG. 13
Screw (2)
15-1/2'' minimum up
from floor. This allows
space to remove and
change filters
Hanger
Washer (2)
Questions? Call Toll Free 1-800-693-1138 Monday- Friday, 7 AM - 6 PM CST
or visit www.ecopurewaterproducts.com
When you call, please be prepared to provide the model, date code and serial number,
found on the rating decal, located inside the cover.