Drucker Diagnostics Model 642VFD Plus Centrifuge - Manual (Page 7)

Page 8 Page 9
To install the rotor:
1. Place the rotor back onto the cone-shaped adapter. You may
need to turn the rotor slightly to line it up properly.
2. The rotor should slide onto the rotor cone freely.
3. Once a proper fit has been achieved, replace the rotor nut and
turn it until it is hand-tight, (a tool may be required).
4. Replace the tube holders and verify that they are seated
properly, (as shown on page 4).
5. It is recommended that the initial setup procedures be performed
to ensure that the rotor has been installed correctly and that no
damage has been done to the centrifuge during either the rotor
installation or possible rotor chamber cleaning. See page 4 for
this procedure.
This page intentionally left blank