Drucker Diagnostics Model 642E Centrifuge - Manual

Operator’s Manual
Model 642E • Laboratory Centrifuge Rev. F
Programmable
Run Time is Factory
Preset to 10
MINUTES
See Page 5
Replacement Parts:
Part No. Description
7724037 Foot, rubber
7751068 Switch, lid safety
7786061 Rotor, six-place, horizontal
7735049 Motor, 1/30 H.P., 115 V.A.C. permanent split capacitor
7729006 Capacitor, 4uF, 250V A.C.
7717051 Electronic timing and locking board
7751043 Circuit Breaker
03-0-0003-0068 Front Panel Label
7760002 Power cord
7714101 Pawl, latch, lid
7714103 Knob, latch, lid
7724071 Hinge, friction
7732018 Seal, lid gasket
7713031 Red Tube Holder, for 17 mm x 100 mm tubes
7713033 Green Tube Holder, for 17 mm x 75 mm Tubes
02-002-1-0011 Lid Assembly
Available Accessories:
Shield caps
p/n 7713011
1” Tube cushion
p/n 1525
Made in the USA by
Protected by U.S. patent # 6,811,531
P/N 03-0-0002-0039
0.5 to 1 mL Tube Adapter
p/n 7713068
13 x 75 mm Insert
p/n 7713064
13 x 100 mm Insert
p/n 7713066
1.5 to 2 mL Tube Adapter
p/n 7713065
200 Shady Lane, Suite 170 • Philipsburg, PA 16866
Phone: 814-342-6205 or 814-692-7661 • Fax: 814-692-7662 • www.druckercompany.com
WARRANTY:
The Drucker Company warranties that this centrifuge is free from defects
in workmanship and parts for 2 years.
0.25” Tube cushion
p/n 9150