Fitting the collar on the dog – Dogtra 1900 Series User Manual

Page 13

TESTING

3. Turn the transmitter on by pressing the blue

button on the right side of the transmitter until
the LCD screen illuminates. The LCD screen
shows the amount of battery life remaining and
the LED blinks once every 2 seconds.

4. Watch the test light as you push the Nick

button on the transmitter. It should light for just
a moment.

5. Watch the test light as you push the Constant

button on the transmitter. It should light for as
long as the button is pressed. However, as a
safety feature, the collar/receiver will
automatically shut off stimulation if the
constant button is depressed for 12 seconds or
longer.

6. Turn the Rheostat Intensity Dial on the

transmitter clockwise and then
counterclockwise. The test light should glow
brighter with higher levels of stimulation and
dimmer with lower levels. When you change
the intensity dial, the number on the LCD
screen will change as well.

7. Pressing the Pager button on the front of the

transmitter causes the collar to vibrate for up to
12 seconds. The collar will reactivate when you
push the button again.

NOTE : The test light may not luminate if the

intensity level is set below level ten.

FITTING THE COLLAR ON THE DOG

PROPER FIT

The collar should be fitted so that the

surgical stainless steel contact points press
firmly against the dog’s skin. You should be
able to fit a finger in between the contact
point and your dog’s skin. The best location
is either side of the dog’s windpipe.