Humboldt HM-1327 Humboldt Marshall/TSR Loader - Manual (Page 7)

1
Quick Start Guide
Startup Scenarios
If your HM-1327 was purchased with instrumentation for
one specific test: the instrumentation has been installed and
calibrated. There is no need to configure or calibrate the machine.
It is ready for use.
DO NOT RECALIBRATE!
Refer to the Installation and Setup Section and then proceed to the
section for the specific test desired.
If your HM-1327 was purchased with instrumentation
for multiple tests: one of those tests is ready for use and the
additional tests may or may not require the mounting of a different
transducer than the one that is currently mounted. However all
instrumentation shipped with your unit is calibrated and assigned
specific input channels for use. These input channels are marked
on the corresponding instrumentation. Unless it is required by your
QC/QA program, there is no need to configure or calibrate the
machine. It is ready for use
.
DO NOT RECALIBRATE!
Refer to the Installation and Setup Section and then proceed to the
section for the specific test desired.
If your HM-1327 was purchased without instrumentation
for specific tests: you will need to acquire, check compatibility,
mount and calibrate your instrumentation for use with the
HM-1327.
Refer to the Installation and Setup Section to make sure if your
instrumentation is compatible with the HM-1327. You will need
to calibrate your instrumentation, please refer to configuration and
calibration instructions. You can then proceed to the Section for
the specific test desired.
2
3
4