Data view version for the system – Bio-Rad LP Data View Software for BioLogic LP System User Manual
Page 4
Data View Version
for the
system
Every effort has been made to ensure that the
Data View software is as trouble-free as
However, any
software application program, certain “bugs” are found after the
is released. This document lists
known
bugs
in
version
and ways to work around them. These bugs will be fixed in a future release of
View. please monitor our
web site at
for information concerning software upgrades.
Bug
Work-around
International versions of
The
Data View program does not
Windows’
work correctly with international
versions of Windows where the comma
and the period characters used in
formatting numbers are reversed from
the US version of Window?.
Manual mode fraction
collection
Time Axis Window Text Box
The
Data View program does not
automatically record data when
fraction collection is started in manual
mode of the
system and
does not reset the fraction number
counter correctly in manual mode.
If an incorrect entry, for example a
blank entry or a decimal point, is made
in the Time Axis Window Text Box
and the user clicks on “Set” or presses
the “‘Enter” key, then the program will
crash display the message “Run time
error ‘
Type mismatch” and crash.
Any unsaved data will be lost, but if
Data Logging was ON the Log file can
be used to recover the data when the
program is started again. To prevent
this problem, always ensure that the
correct numerical entry is made
beforehand.
Change the number formatting charac-
ters to match the US convention. This
is done by opening the “Regional
Settings” program within the Windows
“Control Panel”. Select the
“Number” Tab and change the
“Decimal symbol” to a period and
change the “Digit grouping symbol” to
a comma
Restart your computer
after making these changes. If this
does not work for any reason, you
must install the US version of
Windows@
Click the “record” button on the
bar of
Data View to record data in
manual mode before starting fraction
collection and click on the “stop” but-
ton when fraction collection has been
stopped. To reset the fraction number
counter without running a method on
the
you must exit Data
View
and
then
start
the
program again.
If this situation arises, then PAUSE the
run from the
Controller.
the
Data View program,
save any log file which will contain the
run data and click on
“record”. Then resume the run from
the
Controller.