Mounting of devices, Figure 13 figure 12, Figure 14 – Amico Barcode Dock Mount User Manual
Page 9
www.amico.com
9
Mounting of Devices
Determine the preferred orientation of the barcode charging base and refer to the below illustrations for mounting.
NOTE: The illustrations shown may not portray the configuration purchased. Use this as a reference to pair hardware
and mounting hole pattern with respective barcode scanner base (not provided).
SECTION 4: Device Installation
Figure 13
Figure 12
Barcode charging base with two holes, such as Honeywell
CCB01-010BT for the Honeywell Xenon 1900, 1910, 1902, 1912.
Barcode charging base with one hole, such as Honeywell 2020 for
barcode scanners: 3820, 4620, 4820, or 5620.
Barcode charging base with four holes, such as code reader
CRA-A101 or CRA-A104 for CR2600.
Figure 14
*NOTE FOR ALL OF THE FOLLOWING BARCODE SCANNER
BASES, BASES CAN BE MOUNTED IN THE SAME FASHION
WHEN L-BRACKET IS REVERSED, AS IN -LCD CONFIGURATION
FIGURE 14
FIGURE 13
FIGURE 12
DESCRIPTION:
PART NO:
SCALE:
DRAWN BY:
CHECKED BY:
SHT.
OF
DRAWING NO:
NTS
DATE:
DATE:
PROJECTION
www.amico.com
*NOTE FOR ALL OF THE FOLLOWING BARCODE SCANNER
BASES, BASES CAN BE MOUNTED IN THE SAME FASHION
WHEN L-BRACKET IS REVERSED, AS IN -LCD CONFIGURATION
FIGURE 14
FIGURE 13
FIGURE 12
DESCRIPTION:
PART NO:
SCALE:
DRAWN BY:
CHECKED BY:
SHT.
OF
DRAWING NO:
NTS
DATE:
DATE:
PROJECTION
www.amico.com
*NOTE FOR ALL OF THE FOLLOWING BARCODE SCANNER
BASES, BASES CAN BE MOUNTED IN THE SAME FASHION
WHEN L-BRACKET IS REVERSED, AS IN -LCD CONFIGURATION
FIGURE 14
FIGURE 13
FIGURE 12
DESCRIPTION:
PART NO:
SCALE:
DRAWN BY:
CHECKED BY:
SHT.
OF
DRAWING NO:
NTS
DATE:
DATE:
PROJECTION
www.amico.com
*NOTE FOR ALL OF THE FOLLOWING BARCODE SCANNER
BASES, BASES CAN BE MOUNTED IN THE SAME FASHION
WHEN L-BRACKET IS REVERSED, AS IN -LCD CONFIGURATION
FIGURE 14
FIGURE 13
FIGURE 12
DESCRIPTION:
PART NO:
SCALE:
DRAWN BY:
CHECKED BY:
SHT.
OF
DRAWING NO:
NTS
DATE:
DATE:
PROJECTION
www.amico.com
NOTE: For barcode scanner bases shown in the above illustrations, bases can be mounted in
the same fashion when L-bracket is reversed, as in-LCD configuration.