Great Plains YP1625 Predelivery Manual - Manual (Page 16)

2005+ YP1225 & YP1625
401-226Q 8/15/2006
14
Press Wheel Assembly
NOTE: For shipping purposes, the press
wheel assemblies have been removed
from the openers.
Refer to Figure 17
1. Locate all press wheel assemblies with
cable ties.
2. Match the color of cable tie (4) on each
press wheel assembly (3) to the color of
cable tie (2) on the opener body (1).
3. All press wheel assemblies without cable
ties will match up with all openers without
cable ties.
4. Secure each press wheel assembly (3)
to opener (1) using 1/2-13 x 1 1/2 bolt (6),
1/2 lock washer (9), 1 x 12 pw adjuster
(8), 1/2-13 x 1 bolt (5), and 1/2 lock wash-
er (7).
5. Attach all press wheel assemblies to all
openers.
Alignment
If one press wheel is running in the seed
trench or the wheels are not centered over
the seed trench, adjust the press wheels as
follows:
1. Raise planter slightly to remove weight
from press wheels.
2. Loosen two 1/2” bolts (5 and 6).
3. Turn press wheel adjuster (8) left or right
to center the wheels over the seed
trench.
4. Tighten the 1/2” bolts (5 and 6) to the cor-
rect torque values. Refer to “Torque Val-
ues Chart,” on page 18.
25034
Figure 17
Press Wheel Assembly