Great Plains Simba SL700 Operator Manual - Manual (Page 31)

31 Simba SL700
603-216M-ENG
2013-01-25
5.9 Operator Support
If you have a problem, please contact your
dealer. They will endeavour to solve any
problems which may occur and provide you
with support at all times.
In order to enable your dealer to deal with
problems as quickly as possible, it helps if
you can provide them with the following data.
Always state the:
• Customer Number
• Name and Address
• Machine Model and Serial Number
• Date of Purchase and Operating Hours
• Type of Problem
Avoid sharp-edged and pointed
parts (disc blades, etc.) when
working on the machine.
5.10 Maintenance
Intervals
Apart from daily maintenance, the
maintenance intervals are based on the
number of operating hours and time data.
Keep a record of your operating hours to
ensure that the specified maintenance
intervals are adhered to as closely as
possible.
Never use a machine that is due for
maintenance. Ensure that all deficiencies
found during regular checks are remedied
immediately.
Place the machine on suitable
s u p p o r t s w h e n w o r k i n g
underneath! Do not work under a
machine which is not supported!
On a new machine tighten all nuts and
bolts after 5 hours work and again after 15
hours. This also applies to parts that have
been moved or replaced. After the initial 15
hours of work a once a week check should
be sufficient depending on daily work rates.
5. Servicing and Maintenance