4 spring reset tines, 2 bearing seals – Great Plains Simba SL700 Operator Manual User Manual
Page 29

29
Simba SL700
603-216M-ENG
2013-01-25
5. Servicing and Maintenance
Safely support unfolded machine
in raised position using taps
and stands before attempting
maintenance work on tines.
Do not attempt to assist fitting tine
points with a steel headed hammer,
this can lead to splintering of the
metal due to its hardness, which
can cause injury. If tine fitting
requires assistance, a copper/hide
or plastic mallet should be used.
5.4 Spring Reset Tines
When working under the machine
ensure that the tractor handbrake
is on, the ignition is off and the
keys removed.
When performing maintenance
work on tines extreme care
should be taken. Wear goggles
and gloves at at all times when
maintaining tines.
5.3.2 Bearing Seals
It is important when replacing the labyrinth
type bearing seals in disc hubs that the seal
is fitted the right way round. The chamfered
lip side should be at the outside of the
bearing housing, nearest the disc arm (see
Fig. 5.02). This chamfered lip prevents dirt
ingress into the housing and also allows
grease to be flushed though when greasing.
Fig. 5.02: Correct Seal Orientation
Fig. 5.03: Knock-on Tine Point Removal Tool
STRIKE WITH
MALLET
ENGAGE POINT
REMOVAL TOOL
ITEM PART NO
DESCRIPTION
1
---
DISC ARM
2
P12900
NIPPLE - GREASE M8
3
P14593
HUB CASTING
4
P14594
HUB CAP
5
P12908
SPRING PIN
6
P12907
NUT CASTLE M27x1.5
7
SEAL 64x45x9.5
8
P12415
BEARING 32008 40x68x19
9
BEARING 32206 30x62x21
Chamfered Seal