Great Plains DVN8552 Assembly Manual - Manual (Page 23)

Great Plains Manufacturing, Inc. Assembly 19
02/12/2014 550-353Q-ENG
Install 8321-8324 Wing Fold
Refer to Figure 13
57. Attach 1 1/4 x 9 1/2 eye bolt
, secure with 1 1/4 jam
nuts (one on each side of plate).
58. Mount 3.5 x 8 x 1.25 cylinder to eye bolt and
wheel arm L with 1 x 3 11/16 pins , 1.5 x 1.0 x.075
machine washers and 3/16 x 2 cotter pins.
59. Mount rocker bracket to wing plate with 3/4 x 3 Gr.
5 hex bolts , 3/4 lock washers and 3/4 hex nuts.
60. Attach one end of rocker to rocker bracket using
1 x 3 3/8 pin , 1.5 x 1.0 x.075 machine washer and
3/16 x 2 cotter pin.
61. Bolt the connecting link , with 1 x 3 Gr. 5 bolts , 1
lock washers and 1 nuts.
62. Attach base end of 3.5 x 24 x 1.25 cylinders to
center fold bracket with 1 x 3 11/16 pin , 1.5 x 1.0
x.075 machine washer and 3/16 x 2 cotter pin.
Note: Do not attach rod end of fold cylinders until fold sys-
tem has been purged, See “Purging Hydraulic
System” on page 36.
63. Repeat same procedure for right wing.
64. Tighten all bolts to specs, See “Torque Values
Chart” on page 43.
Figure 13
8321-8324 Wing Fold
41665
10
11
5
1
2
9
3
4
Model8321DoesNot
Use Connecting Link.
6
8
7
4
U
D
F
B
L
R
1
2
3 1
4
5
6
7 5
8
9 10
11
4