Great Plains TA520S Operator Manual - Manual (Page 16)

1993-1995 Tandem Axle Sprayer
500-061M 3/18/2005
14
Before You Start
Read and understand the owners manual for your spray-
er. A basic understanding of how the sprayer works will
aid in the assembly, setup and operation of your sprayer.
Perform these checks before setting up your Tandem
Axle Sprayer.
1. Read and understand “Important Safety Informa-
tion,” beginning on page 1.
2. Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
3. Check that all grease fittings are in place and lubri-
cated. Refer to “Lubrication,” page 56.
4. Check that all safety decals and reflectors are cor-
rectly located and legible. Replace if damaged. Re-
fer to “Safety Decals,” page 8.
Tractor Requirements
To operate your Great Plains Sprayer, a tractor using a
12 volt electrical system must be used.
The tractor will need two hydraulic outlets (one pair) if
the sprayer is equipped with a hydraulic pump.
Before You Start
Read and understand the owners manual for your spray-
er. A basic understanding of how the sprayer works will
aid in the assembly, setup and operation of your sprayer.
Before attempting to assemble the sprayer, use the fol-
lowing as a checklist. Having all the needed parts and
equipment readily at hand will speed up your assembly
task and will make the job as safe as possible.
1.
❑
Check for all sprayer components and hardware.
2.
❑
If a bolt, pin or other component has been removed,
or if you are unsure about where it is used, refer to the
parts section of this manual to identify it.