Great Plains 6328 Series VII Field Cultivator-Floating Hitch Operator Manual - Manual (Page 2)

Great Plains Mfg., Inc. First Page ►
Table of Contents
1/16/2009 Series VII 6113-6328 Field Cultivator, Floating Hitch 560-204M
Table of Contents
Important Safety Information .......................... 1
Safety Rules................................................... 6
Safety Decals ................................................ 7
Introduction ........................................................ 12
Description of Unit ........................................ 12
Using this Manual ........................................ 12
Definitions.............................................. 12
Owner Assistance .......................................... 12
Assembly and Setup Assistance .................... 13
Product Support ..................................... 13
Pre-Assembly Checklist ........................ 13
Section 1 Assembly ............................................. 14
Center Torque Tube & Walking Beam
Assembly ...................................................... 14
6113 & 6116 Wing Frame Assembly ........... 15
6318-6328 Inside Wing and Wheel Arm
Assembly ................................................. 16
Brace Bar and Wing Brace Assembly .......... 17
Wing Fold Bracket Assembly ...................... 17
Level Bar Assembly ..................................... 18
Caster Wheel Linkage & Hitch Pole
Assembly ................................................. 19
Center Lift Cylinder, Rest Pads and
Hydraulic Valves Assembly .................... 20
Fold Cylinders and Rocker Arm Assembly . 21
Center Wing Stop Assembly ........................ 22
Completing Setup ......................................... 23
Section 2 Hydraulics .......................................... 24
Typical Lift Hose Layout ............................. 24
Typical Fold Hose Layout ............................ 25
Section 3 Shank Placement ............................... 26
6113 Shank Layout, Floating Hitch ............. 26
6116 Shank Layout, Floating Hitch ............. 27
6318 Shank Layout, Floating Hitch ............. 28
6320 Shank Layout, Floating Hitch ............. 29
6323 Shank Layout, Floating Hitch ............. 30
6325 Shank Layout, Floating Hitch ............. 31
6328 Shank Layout, Floating Hitch ............. 32
Section 4 Operating and Maintenance
Instructions ......................................................... 33
Prior To Going To The Field ....................... 33
General Operating Instructions and
In-Field Adjustments .................................... 34
Maintenance and Lubrication ....................... 36
Section 5 Specification and Capacities ............. 37
Appendix ............................................................. 38
Torque Values for Common Bolt Sizes ....... 38
Tire Inflation Chart ...................................... 38
Warranty ....................................................... 39
© Copyright 2003 All rights Reserved
Great Plains Manufacturing, Inc. provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the
preparation of this manual, Great Plains Manufacturing, Inc. assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the
use of the information contained herein. Great Plains Manufacturing, Inc. reserves the right to revise and improve its products as it sees fit. This publication describes the state
of this product at the time of its publication, and may not reflect the product in the future.
Great Plains Manufacturing, Incorporated Trademarks
The following are trademarks of Great Plains Mfg., Inc.: Application Systems, Ausherman, Land Pride, Great Plains
All other brands and product names are trademarks or registered trademarks of their respective holders.
Printed in the United States of America.