Great Plains 6328 Series VII Field Cultivator-Floating Hitch Operator Manual - Manual (Page 18)

Section 1: Assembly
Table of Contents ► Great Plains Mfg., Inc..
Series VII 6113-6328 Field Cultivator, Floating Hitch 560-204M 1/17/2005
16
6318–6328 Inside Wing and Wheel Arm Assembly
Bolt the inside wing frames (1) Figure
3, to the center frame with two 1 x 6 hex bolts
(2) with nylon lock nuts (3). Draw the nuts
down tight but do not torque.
Once the wings are attached, insert the
wheel arm bracket (4) into the wing frame
hangers and secure it just as you did on the
center with 1 1/4 x 6 pins (5). Secure the 1 1/4
x 6 pins with the 3/8 x 2 1/4 Gr. 8 hex bolts (6)
& top lock nuts.
Install the wing walking beam assembly
(7) as shown in Figure 3 with the long 14”
spindle toward the front. On models 6318 &
6320, install 14” hub & spindle assembly (11)
as shown in insert. Use anti-seize material on
spindle. Secure the spindle in the sleeve with
the 5/16 x 3 clevis pin (8) and 1/8 x 1 cotter.
Bolt the 9.5L x 15, 8-ply tire(s) (9) in
place with the 1/2 x 1 1/4 lug bolts (10). On
models 6320 & 6325, bolt the 11” bolt on stub
(12) and the 5” bolt on stub (13) to the wing
frame using 5/8 x 1 1/2 hex bolts (14), using
lock washers and hex nuts
Figure 3