Great Plains 2510HDF Operator Manual User Manual
Operator manual, Manufacturing, inc

Manufacturing, Inc.
© Copyright 2013
Printed 2013-11-11
288-340M
EN
ORIGINAL INSTRUCTIONS
Operator Manual
1510HDF, 2010HDF & 2510HDF
15-, 20- and 25-Foot 3-Point
Heavy Duty Fluted Feed Drills
Read the operator manual entirely. When you see this symbol, the
subsequent instructions and warnings are serious - follow without
exception. Your life and the lives of others depend on it!
Illustrations may show optional equipment not supplied with standard unit or may
depict similar models where a topic is identical.
24137
This manual is related to the following products:
Table of contents
Document Outline
- Operator Manual
- Table of Contents
- Important Safety Information
- Look for Safety Symbol
- Be Aware of Signal Words
- Be Familiar with Safety Decals
- Prepare for Emergencies
- Avoid High Pressure Fluids
- Wear Protective Equipment
- Keep Riders Off Machinery
- Use Safety Lights and Devices
- Transport Machinery Safely
- Check for Overhead Lines
- Handle Chemicals Properly
- Shutdown and Storage
- Practice Safe Maintenance
- Tire Safety
- Safety At All Times
- Safety Reflectors and Decals
- Slow Moving Vehicle Reflector 818-003C or 818-055C
- Red Reflectors 838-266C
- Amber Reflectors (large) 838-265C
- Amber Reflectors (small) 818-229C
- Daytime Reflectors 838-267C
- Danger: Cannot Read English 818-557C
- Danger: Crushing Hazard 818-590C
- Warning: Excessive Speed Hazard 818-337C
- Warning: High Pressure Fluid 818-339C
- Warning Marker Pinch Crush 818-682C
- Warning: Falling Hazard 838-102C
- Caution: Tires Not A Step 818-398C
- Caution: Read Manual 818-587C
- Caution: 32 PSI Tire Pressure 818-751C
- Caution: 52 PSI Tire Pressure 818-752C
- Caution: 36 PSI Tire Pressure 818-855C
- Introduction
- Preparation and Setup
- Operating Instructions
- Adjustments
- Planting Depth
- Marker Adjustments
- Material Rate Adjustments
- Row Unit Adjustments
- Troubleshooting
- Maintenance and Lubrication
- Marker Maintenance
- Seed Box Maintenance
- Row Unit Maintenance
- Lubrication
- Gauge Wheel Arm Pivots
- Marker Hinge Points
- Main Seed Cup Drive Shaft Sprocket
- Small Seeds Meter Shaft Bearing
- Fertilizer Shaft Bearings
- Fertilizer Felt Barrier Seals
- Gauge Wheel & Main Box Chains
- Second Box Chains
- Third Box Chains
- Single Gauge Wheel Bearings
- Offset Single Gauge Wheel Bearings
- Dual Gauge Wheel Bearings
- Marker Disk Bearings
- Options
- Appendix
- Index