beautypg.com

Veris drive operating instructions, Sprockets hydraulic system electrical system, Warning – Great Plains 3N-3020 Material Rate User Manual

Page 6: Caution

background image

196-366B

4/28/2004

Great Plains Mfg., Inc.

6

Veris Drive Operating Instructions

Important Safety Information

!

WARNING!

Escaping fluid under pressure can have sufficient
pressure to penetrate the skin. Check all hydraulic
lines and fittings before applying pressure. Fluid
escaping from a very small hole can be almost
invisible. Use paper or cardboard, not body parts, and
wear heavy to check for suspected leaks. If injured,
seek medical assistance from a doctor that is familiar
with this type of injury. Foreign fluids in the tissue must
he surgically removed within a few hours or gangrene
will result.

!

WARNING!

Return hydraulic valve to neutral position before exit-
ing tractor cad. Inadvertent drive rotation could cause
serious injury.

!

CAUTION!

Do not weld on drill unless electronic components are
removed.

Drive Operational Requirements

Sprockets

Refer to Figure 5

Note: For Veris drive set the range sprockets to
drive type 4.

Make sure and set the range sprockets on both
sides of the unit.

Hydraulic System

Closed center, pressure compensated or load
sensed systems only. Drive Will Not operate on
open-centered hydraulic systems.

• Minimum Hyd. Pressure: 2250 psi

• Maximum Hyd. Pressure: 3000 psi

• Maximum Required Flow: 8.5 gpm

Electrical System

• Voltage: 12 volt DC

• Amperage: 4 amperes

Driven

Driver

19113

Figure 5

Sprockets

This manual is related to the following products: