Great Plains 3N-3020 Material Rate - Manual (Page 10)

196-366B 4/28/2004
Great Plains Mfg., Inc.
10
Refer to Figure 14
Enter drill width here using the Up/Down arrow
keys. Press FUNCTION key to advance to next
window.
Refer to Figure 15
Enter the number of rows here using the Up/Down
arrow keys. Press FUNCTION key to advance to
next window.
Refer to Figure 16
Enter your planned planting speed using Up/
Down arrow keys. Calibration mode will not ac-
cept a speed higher than 10 mph. Press
FUNCTION key to advance to next window.
Figure 14
Enter Drill Width
Figure 15
Enter Number of Rows
Figure 16
Enter Planting Speed