Great Plains 3N-3020 Material Rate - Manual (Page 12)

196-366B 4/28/2004
Great Plains Mfg., Inc.
12
Refer to Figure 20
Only after you have verified the drive area is clear,
press the Up arrow key to initiate calibration
mode. If drive area isn’t clear, press Down arrow
key to exit calibration mode.
Refer to Figure 21
Continuing to verify that the area is clear, make
sure you are prepared to capture seed from three
cups and press the ENGAGE key to start drive ro-
tation. Pressing FUNCTION key will exit
calibration mode.
Refer to Figure 22
While the drive is rotating, the display window
shows the time remaining and the "Out" rate.
!
WARNING!
Continue to monitor drive area during drive rotation.
Press the ENGAGE key (or OFF key) to stop drive dur-
ing calibration.
Figure 20
Figure 21
Figure 22