Great Plains 3N-3020 Material Rate - Manual (Page 11)

4/28/2004 196-366B
Great Plains Mfg., Inc. 11
Refer to Figure 17
Enter the amount of seed you want to measure.
For volumetric seeding, this should be at least
1/4 of a lb. Press FUNCTION key to advance to
next window.
Refer to Figure 18
The cab console is informing you the length of
time that the drive will be operating, in order to
measure the amount of seed you have requested,
at the calibration number, drill width and number
of rows you have selected. Press FUNCTION key
to advance to next window.
Refer to Figure 19
!
WARNING!
The drive is about to operate, meaning there is a dan-
ger of entanglement if anyone is in the drive are. Be
sure to verify that no one is near the drive area before
advancing to the next step.
Figure 17
Enter Amount of Seed
Figure 18
Length of Time
Figure 19
Warning!