Prepare agitator shaft components – Great Plains 3S-3000HD Assembly Instructions User Manual
Page 7
Great Plains Mfg., Inc.
Installation Instructions
7
03/24/2009
118-253M
Prepare Agitator Shaft Components
Refer to Figure 9
28. Select three (3) each new:
SPKT 40B17X3/4 HEXBR&LCK COLLR
and six (6) new:
118-494D LOCK COLLAR 3/4 HEX BORE
29. If the sprockets
do not have set screws installed,
select six (6) new:
801-035C SCREW SET 5/16-18 SKT KP X 3/8
Screw the set screws into the sprockets, stopping
just before the tips intrude into the hex bore.
Note that the sprockets
have a raised hub on
one side. When installed, this hub is to drill right.
30. If the lock collars
do not have set screws
installed, select twelve (12) new:
801-035C SCREW SET 5/16-18 SKT KP X 3/8
Screw the set screws into the collars, stopping just
before the tips intrude into the hex bore.
31. At the left end of each box, note the location of the
external hole
for the agitator shaft.
Prepare Agitator Shaft Components
Two people are recommended for this sequence.
At each box.
Refer to Figure 10
32. Insert an inch (2-3cm) of an agitator shaft
through the external shaft hole
.
33. Add a sprocket
to the end of the shaft just inside
the left end wall. Orient the sprocket with the flat
toothed side to the left (onto the shaft first), and the
raised hub (with set screws) to the right. Do not
tighten the set screws at this time.
34. Insert the shaft
through the left end bearing/idler
plate
. When the shaft appears inside the box,
add a lock collar
. Do not tighten the set screws
at this time.
35. Insert the shaft
through the bearings of both
divider panels
. When the shaft appears to the
right of the right divider, add another lock collar
.
36. Insert the shaft through the right end bearing
plate
. Stop insertion when the shaft ends are
about equal distances from both outside end walls.
37. Slide both lock collars
to the outside. Secure
their set screws.
Figure 9
Divider Bearings
29356
U
D
F
B
L
R
5
Figure 10
Divider Bearing Component Order
29356
U
D
F
B
L
R