Great Plains 3S-3000HD Assembly Instructions - Manual (Page 5)

Great Plains Mfg., Inc.
Installation Instructions 5
03/24/2009 118-253M
Pre-Assemble Weldments
Refer to Figure 24
17. Select three (3) new:
195-145H FERTILIZER DRIVE WELDMENT LH
18. Select six (6) sets new:
802-099C HHCS 1/2-13X3 1/4 GR5
817-025C NO. 40 12T IDLER SPKT.
804-015C WASHER LOCK SPRING 1/2 PLT
and twelve (12) new:
803-036C NUT HEX JAM 1/2-13 PLT
804-113C WASHER FLAT 1/2 USS HARD PLT
Assemble and install idlers in the idler slots of left
side of the left-most vertical plate of weldment
.
19. Select three (3) new:
822-119C BRG 7/8HEXX2.05OD SPH
and six (6) new:
822-032C FLANGETTE 52 MST
Insert each bearing in between flangettes .
20. Select six (6) sets new:
802-282C RHSNB 5/16-18X1 GR5
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
Mount each bearing assembly on the left side of the
left-most vertical plate of the weldment
. Thread
nuts on only to finger tight.
Install Shafts and Paddles
Remove End Panel Covers
Refer to Figure 6
21. At all end panel covers (
and ), remove and
save four (4)sets (24 sets total):
803-014C NUT HEX 3/8-16 PLT
804-011C WASHER FLAT 3/8 USS PLT
802-079C HHCS 3/8-16X1 1/4 GR5
which may include 24 or 48:
804-013C WASHER LOCK SPRING 3/8 PLT
22. Remove one each:
195-101D INTERIOR ENDPANEL COVER LH
195-102D INTERIOR ENDPANEL COVER RH
These panels are not re-used.
Figure 5
Pre-Assemble a Weldment
29361
22
58
56
56
45 38
35
48 42 54
33
48
42
46
22
33
54
46
42
48
22
58
56
58 56
35
45
38
22
Figure 6
Existing End Panel Covers
17039
85
89
88
88
89
83
85
74
75
83
U
D
F
B
L
R
74 75
85
88
83
89
74
75