Great Plains 3S-3000HD Assembly Instructions - Manual (Page 14)

Great Plains Mfg., Inc.
14 Main Seed Box Agitator Kit
118-253M 03/24/2009
Refer to Figure 23
80. With sprockets facing left, place the updated clutch
back between the input and output shafts.
81. Select one new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
Push the input shaft left. Drive the pin into the
shaft hole at the left of the right end support
weldment
. Release the clutch spring from park-
ing groove.
82. Re-mount the saved ground drive input sprocket
on the right end of the input shaft, with raised hub to
left. Re-mount chain and re-engage idler.
83. At the clutch, re-mount the chain on the (right)
clutch sprocket . Re-engage the chain idler.
Install Auxiliary Drive Weldments
(all sections)
Refer to Figure 24
84. Select the three (3) new:
195-145H FERTILIZER DRIVE WELDMENT LH
pre-assembled at step 17,
and six (6) sets new:
802-034C HHCS 1/2-13X1 1/4 GR5
804-015C WASHER LOCK SPRING 1/2 PLT
803-020C NUT HEX 1/2-13 PLT
Loosely secure weldment to the gusset plate
at the front left corner of each section frame.
85. Select three (3) new:
195-212D ANGLE, FERTILIZER DRIVE MOUNT
806-060C U-BOLT 1/2-13 X 6 1/32 X 7 1/4
and six sets new:
804-015C WASHER LOCK SPRING 1/2 PLT
803-019C NUT LOCK 1/2-13 PLT
Loosely secure each weldment to the front tool bar
and the angle
using the U-bolt.
86. Select six (6) sets new:
802-034C HHCS 1/2-13X1 1/4 GR5
804-015C WASHER LOCK SPRING 1/2 PLT
803-020C NUT HEX 1/2-13 PLT
Loosely secure the weldment to the angle . Slide
the weldment tight against the left frame and tighten all bolts to torque spec.
Figure 23
Re-install RH Clutch
27474
49
77
6
4
1
93
77 6
49
77
4
1
93
Figure 24
Install Accessory Weldment
29362
1
22
30
39
46
50
40
46
26
30
22
30
46
40
22 1
26
50
46
39
26
30
46
40
26