Great Plains 3S-3000HD Assembly Instructions - Manual (Page 6)

Great Plains Mfg., Inc.
6 Main Seed Box Agitator Kit
118-253M 03/24/2009
Install Bearing Plates
Refer to Figure 7
23. Select the six (6) bearing plate assemblies:
Right end, bearing only
Left end, bearing and sprocket(s)
24. Install the bearing plates where the end panel cov-
ers were removed, using for each plate, four sets of
saved bolts
, flat washers , lock washers
and nuts (not shown).
If only one lock washer is available per saved
bolt, place it under a nut .
Install Divider Bearings
Refer to Figure 8 (which depicts components outside the seed
box for clarity - do not remove dividers)
25. Select six (6) new:
822-128C BRG INS 3/4HEXX1.85OD SPH
and twelve (12) new:
822-041C FLANGETTE 47 MST
Insert each bearing in between flangettes .
26. Select twelve (12) sets new:
802-009C RHSNB 5/16-18X1 1/4 GR5
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
27. At each divider panel , install a bearing assembly
( - - ) with two sets of square neck bolts ,
lock washers and nuts .
Mount assembly on whichever side of the divider
places the bearing further from seed cup center-
lines. Spin on nuts only to finger-tight.
Figure 7
New End Panel Bearing Plates
17042
U
D
F
B
L
R
19
20 89
88
83
19
20
83 88 89
85
89
85
Figure 8
Divider Bearing Component Order
29356
U
D
F
B
L
R
38
4
45
29
57
59
57
59
57
59 57
29
45
38
4
57 59 57 29
45 38