Great Plains Inline Ripper Gauge Wheel Jack Kit - Manual (Page 2)

596-158M 5/4/2005
Great Plains Mfg., Inc.
Inline Ripper Gauge Wheel Jack Kit 2
Mounting the Jack on Gauge Wheels with 12"
Clearance
Refer to Figure 2
1. After determining 12" clearance between the front
of the frame tube to tires or hitch, grind paint on
bottom portion of front of the gauge wheel arm
(2).
2. Center and align gauge wheel jack lower mount
(1) flush with the bottom of the gauge wheel arm
(2). Weld mount (1) on arm (2).
3. Grind paint on the gauge wheel mount (3). Center
and align upper jack mount plate (4) flush with the
bottom of the gauge wheel mount (3). Weld plate
(4) to gauge wheel mount (3).
4. Repeat steps 1-3 on opposite side of inline ripper
frame. Paint new parts with Great Plains Green
available at the nearest authorized Great Plains
dealer.
Figure 2
23175