Great Plains 3000TM Assembly Manual - Manual (Page 35)

Great Plains Manufacturing, Inc. Assembly 31
11/12/2013 586-536Q-ENG
Proximity Sensor Adjustment
Refer to Figure 26
Note: Wings need to be folded up when adjusting the
proximity sensor to prevent damage to sensor
and bracket. Be sure and adjust proximity sensors
before unfolding. Be sure wing safety lock pins are
installed
117.Loosen nuts (one on front and one on back side of
sensor bracket, adjust the proximity sensor to 1/8”
to 1/4”, from front of proximity sensor to rear of
wing tube as shown.
118.Re-tighten nuts to secure proximity sensor .
Gang Cylinder Purging
Refer to Figure 27
Note: Refer to hydraulic layouts in “Appendix” section of this
manual for proper gang hose routing on center and
wings. See “Hydraulic Connector ID” on page 40 for
proper fitting installation. See “Hose Clamp Assembly”
on page 17 for proper clamping of hoses.
119.Retract and extend the gang system (Red Handles)
several times to purge air from system. Watch for leaks
and retighten fittings if necessary.
1
2
1
3
4
2 1
Figure 26
Priority Sensor Adjustment 43015
2
4
3
1
2
1
U
D
F
B
L
R
Figure 27
Gang Cylinder Purging
42978
1
1