Great Plains 3000TM Assembly Manual - Manual (Page 33)

Great Plains Manufacturing, Inc. Assembly 29
11/12/2013 586-536Q-ENG
Rear Lights and SMV Assembly
Refer to Figure 24
106.Fasten LH and RH light brackets to rear of cen-
ter frame or center drag frame (if equipped) with
3/4.x 2 hex bolts , 3/4 lock washers and 3/4 huts.
107.Route light harness dual amber along rear tube of
center frame and outer amber leads to light brackets
(either on rear of center frame or center drag frame).
108.- Mount amber lamp lights to top of light brackets
and , with 1/4 x 1 Gr. 5 hex bolts and 1/4 lock
nuts. Plug leads of amber lamp lights to amber
leads of light harness dual amber .
109. Mount red lamp lights to center frame plates with
1/4 x 1 Gr. 5 hex bolts and 1/4 lock nuts. Plug
leads of red lamp lights to red leads of light har-
ness dual amber .
110. Attach smv mount to rear tube of center frame
, with 1/2 x 3 1/32 x 6 u-bolts , 1/2 lock washers
and 1/2 huts. Attach smv sign to back side of smv
mount , secure with 1/4 x 3/4 pan head screws ,
1/4 lock washers and 1/4 nuts.
111.Tighten all bolts with lock nuts snug, but do not
torque. The rest of the bolts may be tightened to
specs, See “Torque Values Chart” on page 38. Be
sure and get all wiring harnesses fastened up
securely with hose wraps or clamps (if routed close
to hydraulic hoses) or use cable ties
.
1 2
4 5
3
6
7
1 2 8
7
6
9
8
9
6
10
4 11
12
10 13
14
8
7
1
14
3
6
8
9
12
13
10
11
4
9
8
7
2
14
6
7
5
2
7
1
3
Figure 24
Rear Lights & SMV 43235
U
D
F
B
L
R