Wheatheart WHR 130 x 31-36ft Augers PTO-SD - Manual (Page 41)

WHEATHEART - GHR130 & WHR130 GRAIN AUGERS 6. M AINTENANCE & S TORAGE
PTO-SD & EMD D RIVE M ODELS 6.2. G ENERAL S TORAGE P ROCEDURES
16652 R1 41
6.2. GENERAL STORAGE PROCEDURES
T O PROTECT AUGER IN STORAGE DURING THE OFF - SEASON :
1. Lower the auger to full down position with slight tension on the cable.
2. Lubricate all grease fittings according to the maintenance procedure.
3. Inspect auger for damage and note any repairs required. Order replacement
parts from your dealer.
4. Check tire pressure and inflate according to side wall recommendations.
5. Clean and re-lubricate the spline on PTO driveline. Cover PTO driveline with
a plastic bag to protect it from the weather and place it in the transport
saddle.
6. Cover motor with protective covering to protect from weather (where
applicable).
7. Tow auger to storage area. Park and chock wheels.
T
O PREPARE AUGER FOR USE AFTER STORAGE
:
1. Check tire pressure and inflate according to side wall recommendations.
2. Tow auger to work site.
3. Remove cover from spline of PTO driveline and re-lubricate.
4. Check oil level in gearbox and refill if necessary (half full only).
5. Replace any damaged parts and decals.
6. Check and perform general maintenance before using auger.
7. Before raising auger after storage, make certain cable is in good condition,
replacing it if frayed or damaged. Also make sure cable is properly seated in
roller track and that cable clamps are secure.
8. On augers equipped with lubricated upper drive, check level annually and
add as needed (fill to plug level).
9. Remove protective covering from motor (where applicable).
Note:
Use only genuine WHEATHEART replacement parts or equivalent. Replacement
parts such as intake guards, pulley guards, PTO driveline shields, winches and
lift cables must meet ASAE standards or serious injury may result. Use of
unauthorized parts will void warranty. If in doubt, contact WHEATHEART or your
WHEATHEART dealer. Do not modify any auger components.
CAUTION
Support discharge end of auger before
removing or replacing any parts on the
undercarriage.