Wheatheart WHR 130 x 31-36ft Augers PTO-SD - Manual (Page 33)

WHEATHEART - GHR130 & WHR130 GRAIN AUGERS 5. O PERATION
PTO-SD & EMD D RIVE M ODELS 5.1. A UGER D RIVE & L OCKOUT P ROCEDURE
16652 R1 33
5. Operation
Operators must observe safety procedures at all times and follow the pre-opera-
tional checklist before each start-up.
Pre-Operational Checklist
Before operating auger each time, the operator must confirm the following:
• All fasteners are secure as per assembly instructions.

• PTO SD Models:
• Driveline is connected and secure.
• Driveline shield rotates freely.

• EMD Models:
• Drive belt(s) are not frayed or damaged.
• Drive belt(s) are properly adjusted and aligned.
• Lift cable is not frayed or damaged.
• Lift cable is properly seated in cable sheaves.
• Cable clamps are secure.
• Tube alignment is reasonably straight.
• Auger wheels are chocked, and

• PTO SD Models: tractor wheels are chocked or the parking brake has been
engaged.
• Intake area and discharge spout are free of obstructions.
• Proper maintenance has been performed.
5.1. AUGER DRIVE & LOCKOUT PROCEDURE
Warning: Before continuing, ensure you have read and understand the relevant information
in the safety section. Safety information is provided to help prevent serious injury, death, or
property damage.
Drive
Type
Before Operation Lockout
Electric
Motor
Before starting motor, ensure
• motor is properly grounded
• pulley shields are in place and secure
The electric motor should be
equipped with a main power
disconnect switch capable of being
locked in the off-position only. The
switch should be in the locked
position during shutdown or
whenever maintenance is performed
on the auger.
• If reset is required, disconnect all
power before resetting motor.