Wheatheart WHR 130 x 31-36ft Augers PTO-SD - Manual (Page 25)

WHEATHEART - GHR130 & WHR130 GRAIN AUGERS 3. A SSEMBLY
PTO-SD & EMD D RIVE M ODELS 3.10. W INCH & L IFT C ABLE
16652 R1 25
5. Wrap cable 1-1/2 times around the
cable attach rod and secure with
three cable clamps. Position cable
clamps as shown in Figure 3.16
and 3.17. Tighten cable clamps
securely.
Make certain cable is properly seated
in cable groove before raising auger.
Figure 3.17
3.10.1. W INCH H ANDLE
This auger may use one of several different winch models. Before installing
handle on the main winch assembly, check the model number stamped on winch
housing and follow the correct set of instructions.
M ODEL K2550
1. Slide handle over flat
sides of input shaft.
2. Fasten with 1/2” locknut.
Do not remove or loosen the
locknut on brake side of
winch: it is an important part
of the brake system of the
winch.
Figure 3.16
Note:
CAUTION
Winch handle assembly must follow the
instructions below. Improper assembly will
result in sudden winch failure causing
damage to equipment and/or personal injury.
Figure 3.18
Important: