Monarch Instrument Pocket LED Strobe - Manual (Page 14)

10
3.3.2 BRITE (Brightness)
Adjust the fl ash pulse width and consequently the brightness. See
Section 1.2. When the display shows:
SEtUP
BRITE
Press the MENU button to enter. Width can be set in degrees or
microseconds.
DEG - Set the fl ash width in degrees 0.2° to 18°. Use the UP/
DOWN button ▲▼ to change the degrees in 0.2° steps. Note
that the decade being edited can be changed using the LEFT
◄
or RIGHT ► buttons.
5.6
DEG
Press the MENU button to move to microseconds.
uSEC - Set the fl ash width in microseconds. Maximum and
minimum are equivalent to 0.2 to 18 degrees or 2500 uSec,
whichever is less.
1234
uSEC
The display will be a conversion of the degrees to microseconds
for the current fl ash rate. To accept this press MENU again.
To adjust the fl ash rate in microseconds, use the ▲▼ button.
Note that the decade being edited can be changed using the
LEFT ◄ or RIGHT ► buttons.
Press MENU to save and return to the main menu.
3.3.3 SAVE
Saves the current fl ash rate to a memory location. When the
display shows:
SEtUP
SAVE