Monarch Instrument Nova-Strobe PBL - Manual (Page 23)

19
Allow the recharger to charge the batteries until the display shows
DONE for peak battery life performance. If the batteries are not charged
to 100% regularly, the batteries will lose capacity.
5.3 External Power Supply/Charger (PBL only)
The PBL will run continuously from the external power supply/charger
(PSC-PBXU) powered by the AC mains (115 – 230 Vac).
To run the PBL from the external power supply/charger
(PSC-PBXU):
1. Plug the recharger cable into the recharger socket (located below
the display panel behind the handle).
2. Plug the recharger into an AC mains wall outlet (115/230 Vac).
3. Press the trigger switch to operate as normal. If the trigger switch
is not pressed, the strobe will start charging. The batteries ARE
NOT charged while the strobe is operational and running off the
power supply/charger.
5.4 Stroboscope Disposal
Prior to disposing of the battery-powered strobe, the user
must remove the Nickel-Metal Hydride batteries. To do this,
remove the LED assembly fi rst. This will expose four (4)
screws that must be removed so the refl ector housing can be
dismantled. There are four (4) additional screws in the case half opposite
the input and output jacks that must be removed. The case halves can
now be separated, exposing the batteries. Remove the cables from the
batteries and place tape over the battery terminals to prevent them from
shorting. The batteries should be sent to a recycling center or returned
to the factory. The rest of the parts may now be disposed of.