Dymo LabelManager 350D - Manual (Page 5)

5
About Your New Label Maker
With your new DYMO LabelManager 350D electronic label
maker, you can create a wide variety of high-quality,
self-adhesive labels. You can choose to print your labels in
many different sizes and styles. The label maker uses DYMO D1
tape cassettes in widths of 6 mm (1/4”), 9 mm (3/8”), 12 mm
(1/2”), or 19 mm (3/4”). These tape cassettes are available in a
wide range of materials.
Visit www.dymo.com for information on obtaining tapes
and accessories for your label maker.
Warranty Registration
Visit www.dymo.com/registration to register your label
make online.
Getting Started
Follow the instructions in this section to print your first label.
Connecting the Power
The label maker can operate on AC or battery power. To save
power, the label maker will automatically turn off after two
minutes of inactivity.
Inserting the Batteries
The label maker uses six AA batteries.
To insert the batteries
Remove the battery compartment cover. See Figure 2. 1.
Figure 2
Insert the batteries following the polarity markings 2.
(+ and –).
Close the compartment door. 3.
x Remove the batteries if the label maker will not be used
for a long period of time.
Connecting the Power Adapter
Connecting the power adapter to the label maker disconnects
the batteries as a power source.
To connect the power adapter
Plug the power adapter into the power connector on the 1.
top, left side of the label maker.
Plug the other end of the power adapter into a power 2.
outlet.
x Make sure you disconnect the label maker from the power
adapter before you unplug the adapter from the main power
source. Otherwise, the most recent memory settings will be
lost.
Inserting the Tape Cassette
Your label maker comes with one DYMO D1 tape cassette.
Visit www.dymo.com for information about purchasing
additional tape cassettes.
To insert the tape cassette
Press and release the tape cassette cover to open the tape 1.
compartment. See Figure 3.
Figure 3
LM350D manual UK_WEU.indd 5 09-08-2007 13:44:26