Dymo LabelManager 350 - Manual (Page 3)

About Your LabelMANAGER 350
Electronic Labelmaker
The LabelMANAGER 350 electronic labelmaker
allows you to create a wide variety of high-
quality, self-adhesive labels. You can choose to
print your labels in many different sizes and
styles. The labelmaker uses D1 tape cassettes
in widths of 6 mm (1/4”), 9 mm (3/8”), 12 mm
(1/2”), or 19 mm (3/4”). These tape cassettes
are available in a wide range of colors. Visit
www.dymo.com for information on obtaining
tapes and accessories for your labelmaker.
Warranty Registration
Please complete the warranty registration card
and return it to the appropriate customer
service address within seven days. See the
Warranty booklet for details.
Getting Started
Follow the instructions in this section to get
started printing your first label.
The labelmaker uses six AA batteries.
To insert the batteries
1. Remove the battery compartment cover.
See Figure 2.
Figure 2
2. Insert the batteries following
the polarity markings (+ and –).
3. Close the compartment door.
Remove the batteries if the labelmaker will
not be used for a long period of time.
Connecting the power adapter to the
labelmaker disconnects power from the
batteries.
To connect the power adapter
1. Plug the power adapter into the power
connector on the top, left side of the
labelmaker.
2. Plug the other end of the power adapter into
a power outlet.
Make sure you disconnect the labelmaker
from the power adapter before you unplug the
adapter from the main power source.
Otherwise, the most recent memory settings
will be lost.
To insert the tape cassette
1. Press and release the tape cassette cover to
open the tape compartment. See Figure 3
Figure 3
Inserting the Tape Cassette
Connecting the Power Adapter
Inserting the Batteries
3
GB
LM350 WEU.qxd 12-11-2003 09:02 Pagina 3