LaMotte Mobile WaterLink Spin Photometer - Manual (Page 9)

9
SET UP
 DISKS
1. Each box contains 50 disks for one series, either the chlorine/bromine series
or the biguanide series. Remove a disk from the packaging as needed.
2. Avoid opening more packages than you need. Disks have a limited shelf life
and should not be exposed to the humidity in the air more than necessary.
 METER
The battery must be charged before the fi rst use.
3. Plug the battery charger into an AC outlet. The LED on the battery charger will
be green.
4. Plug the battery charger into the battery pack. The LED will be red.
5. When the battery is fully charged the LED on the battery pack will be
green.
6. Disconnect the battery charger from the battery pack.
7. Disconnect the battery charger from the wall socket.
8. Connect the battery pack to the meter.
9. Press the button on the battery pack to turn the meter on.
10. Begin testing.
NOTE: The meter can be used when the battery pack is connected to the battery
charger when it is plugged into an AC outlet.
 APPLICATION
The WaterLink Spin app must be downloaded and installed to a smartphone or
tablet to operate the device. The WaterLink Spin app supports two modes for
testing: “Offl ine” and “Connected to a Water Analysis Program.” This setting can
be toggled on the Settings Tab of the WaterLink Spin app by unchecking the
“Connect to Water Analysis Program” checkbox for offl ine mode.
Currently, Android smartphones and Tablets are supported.
Offl ine
1. Follow the instructions for connecting the device via Bluetooth
2. On the Controls Tab, select a Test Series from the dropdown at the top.
3. Tap the Spin button
4. Results will be displayed in the white box on the right hand side of the screen
NOTE: Test results are not saved when running in Offl ine mode
Connected to a Water Analysis Program
1. Follow the instructions for connecting the device via Bluetooth
2. On the Controls Tab, log in to the water analysis program