Culligan Gold SeriesTM - Manual (Page 11)

9
Programming
Press ▲ to increase or
▼ to decrease
The Culligan
®
AccuSoft
®
circuit board controls all of the softener functions. These settings are
programmed at the time of installation. The following is a list of all the microprocessor
functions, in the event that any of the settings need to be adjusted. If a small padlock icon
appears in the lower right corner of the display, the microprocessor settings are locked and only
the Time-of-Day setting can be adjusted, call your Culligan Dealer if setting changes are
required.
1. With a flashing or blank display, pressing the status
button twice will move to the Time-of-Day
adjustment. A number “1” will appear at the bottom
of the display while in this mode.
2. Press status again, this displays the Time-of-Regenera-
tion. A number “2” will appear at the bottom of the
display while in this mode.
3. Press status again, the number “3” will appear at the
bottom of the display. This setting is not used.
4. Pressing status again will show the Salt Dosage. This
can be adjusted from 3-15 lbs. for the 9” and 5-24 lbs.
on 12” models. A number “4” will appear at the
bottom of the display while in this mode.
5. Press status again, this displays the Backwash Time.
The setting can be adjusted between 5 and 40 minutes.
A number “5” will appear at the bottom of the display
while in this mode.
6. Press status again to display the Brine/Rinse Time.
The settings can be adjusted from 37-85 min for 9”,
and 35-89 min for 12”. A number “6” will appear at
the bottom of the display while in this mode.
Press ▲ to increase or
▼ to decrease
Press ▲ to increase or
▼ to decrease
Press ▲ to increase or
▼ to decrease
Press ▲ to increase or
▼ to decrease