Tweco W4016300 - Manual (Page 7)

Manual 0-5228 7 Spool Cover Assembly Instruction
SPOOL COVER ASSEMBLY ( W4016300 ) INSTRUCTIONS
Assembly Procedure For Transmig VAF4 and VAF4 HD Wirefeeders
Spool cover is assembled in the following steps:
1. Remove the spool hub assembly.
a. Remove the clip from the spool hub.
b. Unscrew the 3-lobe screw.
c. Remove the spool hub parts and the spacer in the following sequence. Note that the spacer is not
required when fitting the spool cover.
Hexagon Nut
Spring Washer
Flat Washer,large hole
Spacer
Shaft
Friction Washer
Hub Wire Reel
Keyed Washer
Compression Spring
Flat Washer, small hole
3-lobe Screw
Retaining Clip
Art # A-11514
Figure 2 Removing Spool Hub Assembly (For Transmig VAF4 and VAF4 HD Wirefeeders)
2. Assemble the Spool Cover Mounting Brackets, one inside and one outside the spool cover, with the two
countersunk screws M5 x 12.
3. Secure the spool cover assembly to the spool support arm with M12 x 30 Bolts, Star Washers, M12, and
Flat Washers, M12 as shown in the diagram below.
Art # A-11344
Spool Cover Mounting Brackets
Spool Cover
Countersunk Screws,
M5×12
Hub Wire Reel
Keyed Washer
Compression Spring
Flat Washer, small hole
3-lobe Screw
Retaining Clip
Friction Washer
M12 x 30 Bolts;
Star Washers, M12;
Flat Washers, M12
Figure 3 Installing Spool Cover (For Transmig VAF4 and VAF4 HD Wirefeeders)