Tweco 9-9436 User Manual
General information, Supplied parts, Installation

April 4, 2006
1
Manual 0-4743 Rev. AA
© 2005 Thermadyne Corp.
Manual 0-4743
Torch Valve Kit No. 9-9436
Installation Instructions
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com
General Information
This kit is for use only with Thermal Dynamics Auto-Cut
®
20O
2
and 30O
2
Power Supplies and Thermal Dynamics
Plasma Cutting Machine Torches. Do not use this kit with
any other equipment.
This kit accepts preflow, plasma, and shield gases and
water from the Gas Control Module and supplies these
gases to the Torch.
Supplied Parts
• Torch Valve Assembly
• Installation Instructions
Art # A-04760
3.72 in
95 mm
3.34 in
85 mm
4.63 in
118 mm
2.06 in
52 mm
Installation
WARNING
Disconnect primary power at the source.
1. Mount the Valve Kit as close as possible to the Torch.
The valve kit can be mounted in any convenient posi-
tion, provided the outlet side (with two fittings) is closer
to the torch than the inlet side (with three fittings and a
control cable connector).
2. Connect the Valve Kit outlets to the torch leads as
shown.
Art # A-04761
Right-hand Thread:
To Torch Shield Gas fitting
Left-hand Thread:
To Torch Plasma Gas fitting
Do not remove brass plugs
Outlet Side