Tweco 9-9488 - Manual

Manual 0-4951 1
Original Publication Date: 2003 Manual no.: 0-4951
Revision Date: 5/05/2014 Revision: AJ
General Information
This kit is for use only with Victor Thermal Dynamics
XT-Series Torches. Do not use this kit with any other
equipm ent.
Read these instructions before starting the replacement
procedure. Keep these instructions for future reference.
CAUTION
Only a qualified technician should perform this
procedure.
Parts Supplied
The kits includes:
• Torch O-Rings
• Cartridge O-Rings
• Cartridge Baffle O-Ring (xx-1022)
• Victor Thermal Dynamics Cat. No. 9-4893 O-Ring
Lubricant
• Instructions
Procedure
WARNINGS
Disconnect primary power at the source and bleed
down the system before starting this procedure.
1. If necessary, raise the torch away from the cutting
table to provide working room.
2. Remove the Shield Cup Assembly (including the
cartridge assembly and consumables).
CAUTION
Use only Victor Thermal Dynamics No. 9-4893
O-Ring Lubricant (Christo Lube MCG-129) with
this torch part. Use of other lubricants may cause
irreparable damage to the torch.
Torch O-Ring Change
1. Find and open the bag labeled Torch O-Ring Kit.
Verify that you have a new O-Ring for each of
the ones being replaced on the Torch. See Illustra-
tion.
Art # A-04066_AC
O-Rings
Cat. No. 9-3027
Cat. No. 9-3026
Cat. No. 9-3025
Torch Head
Cat. No. 9-9041
Torch View
2. Remove and discard each of the old O-Rings from
the Torch.
3. Clean each of the O-Ring grooves with a soft
bristle brush or lint free cloth.
4. Find the large yellow O-Ring and place it on the
Torch where the old one was. Do Not Lubricate
the yellow O-Ring.
O-Ring Kit No. 9-9488
for XT-Series Torch
Installation Instructions
Baffle O-ring
not shown.