CITIZEN CMP-30 - Manual (Page 24)

24
3.4 Charging the Battery
Be sure that the printer is turned off and AC plug is correct one. (1)
If AC plug is wrong, change the plug to correct one.
Open the DC Jack cover by pulling on the rubber cover and insert
(2)
DC JACK into the printer.
Plug the power code to electrical outlet.
(3)
The Charge Indicator LED is on the AC Charger itself (not the (4)
printer) and shows red or green according to the status.
NOTE
In case of a trouble while charging the battery, the charge is suspended with
charge LED blinking Green. Try unplugging and reconnecting charger, then
charge should resume. The charging is completed when the LED changes to
solid (continuous) green.
NOTE
Unless the exclusive charger is used provided by the manufacturer, 1.
the printer can be damaged, and the manufacturer is not liable for the
consequential damage.
Before removing the battery, make sure that power is turned off.
2.
A battery must be installed for printing. The printer will not operate from 3.
the charger alone.
It is not recommended to use or operate the printer whilst charging as it
4.
can reduce the battery's overall lifetime.