Sound Devices 633 - Manual (Page 32)

Output Setup and Control
Master Outputs (XLR-3M)
Master Left (L) and Right (R) analog signal output is provided on a pair of balanced XLR-3M
connections. Each output can be independently set to Line (+4 dBu nominal), -10, or Mic level
(40 dB of attenuation versus Line) from the Setup Menu options OUTPUTS > XLR-L Out and
OUTPUTS > XLR-R Out. The master outputs are capable of driving long cable runs.
When set to output analog signal, the Master XLR-3M Outputs always carry the L and R bus signal,
respectively. Signal is routed to the L and R buses from each inputs’ Input Settings Screen by sliding
the RTN / FAV Switch left or right. Both the Left (L) and Right (R) XLR-3M outputs can be indepen-
dently set to provide AES digital signal. Various sources can be routed to AES Digital Outputs. ( See
“AES3 Digital Outputs (XLR-3M)”, page 27 )
AUX 1/2 Outputs (TA3)
AUX 1 (X1) and AUX 2 (X2) analog signal output is provided on a pair of balanced TA3 con-
nections. Each output can be independently set to Line (+4 dBu nominal), -10, or Mic level
(40 dB of attenuation versus Line) from the Setup Menu options OUTPUTS > TA3-X1 Out and
OUTPUTS > TA3-X2 Out.
Signal can be quickly routed to the X1 and X2 buses from each inputs’ input Settings screen by slid-
ing the Mic / Tone Switch left or right.
Signal can also be routed to the X1 and X2 buses from the X1, X2 Routing Screen ( See “Rout-
ing Screens”, page 13 ). The X1, X2 Routing Screen is accessed from Setup Menu option
OUTPUTS > X1, X2 Routing. ISO tracks or L and R tracks can be routed individually to X1 and X2
buses (routing any ISO track to a bus will unroute tracks L and R to that bus and routing L or R to
any bus will unroute any ISO tracks to that bus).
Highlight the routing and press the Headphone Encoder to adjust the routing between off (black),
post-fade (Blue), or pre-fade (Green). L and R tracks can only be routed post-fade. Selecting the
All ISO Tracks option on this routing screen will change all active X1, X2 routes to pre- or post-fade.
Post-fade routing
Pre-fade routing
AUX 3/4 Outputs (TRS)
AUX 3 (X3) and AUX 4 (X4) analog signal output is provided on a single, 3.5 mm, TRS connection.
This connection is wired unbalanced with Tip: X3 positive, Ring: X4 positive, Sleeve: Shared ground.
Signal is routed to the X3 and X4 buses from the X3, X4 Routing Screen ( See “Routing Screens”, page
13 ). The X3, X4 Routing Screen is accessed from Setup Menu option OUTPUTS > X3, X4 Routing.
633 User Guide and Technical Information
26
v. 1.02 Features and specifications are subject to change. Visit www.sounddevices.com for the latest documentation.
Output Se
tup and Contr
ol