SONIQ QMD78DS - Manual (Page 14)

- 13 -
Playing a Disc
1. Slide the STANDBY / ON switch to the ON position. (Slide the ON / OFF switch on the monitor to the ON
position.) See CUSTOMIzING THE FUNCTION SETTINGS before proceeding to step 2.
2. Press the OPEN button and hold the front panel to open the disc door.
3. Hold the disc by its sides and gently push it onto the spindle with label side facing towards you until you hear
a “click”.
4. Gently push the disc door closed. It takes a short while for your unit to load the disc. After loading, for most
DVDs, the unit will automatically take you main menu or start playing. If the unit does not automatically start
playing the DVD, press the
PLAY button.
Pausing Playback (Still Mode)
Press the PAUSE button. To resume normal playback, press the PLAY button.
Each time you press the PAUSE button, the picture advances one frame.
Stopping Playback
Press the STOP button at the location where you want to interrupt playback. To resume playback at the
position where the disc was stopped, press the PLAY button.
If you press the STOP button twice, the unit’s memory will be cleared and pressing the PLAY button will
reset the disc to the beginning.
Fast Forward / Fast Reverse
1. Press the SEARCH or SEARCH button when a disc is playing. Each time you press the SEARCH
or SEARCH button, the playback speed changes in the following sequence:
2. Press the PLAY button when you reach the desired point to resume normal playback.
Note:
• The DVD player mutes sound and subtitles during reverse and forward scan of DVDs.
• The fast playback speed may differ depending on the disc.
Skip (Forward / Reverse)
• Press the PREV button to go back to current or previous chapters/tracks.
• Press the NEXT button to advance chapters/tracks.
• For audio CDs, use the number buttons on the remote control to jump immediately to the desired track
number.
Audio Selection
On some DVDs, the sound is recorded in two or more formats. Follow the directions below to select the preferred
language and sound system.
1. While a disc is playing, press the AUDIO button to show the current audio format number.
2. Press the AUDIO button repeatedly to select the desired audio format.
Note:
• If only one audio format is recorded on the DVD, the number does not change.
• Some DVDs allow you to change audio selections only via the disc menu. If this is the case, press the MENU
button and choose the appropriate language on the disc menu.
• You can select different audio channels (Stereo, Left or Right) on an Audio CD by pressing the AUDIO button
repeatedly.
This instructional manual explains the basic instructions for operating this unit. Some DVDs are produced
in a manner that allows specific or limited operation during playback. Therefore, this unit may not respond
to all operating commands. THIS IS NOT A DEFECT. Please refer to the instructions accompanying the
specific DVD in question for more information about the options available on that DVD.
“
” may appear on the screen during operation. A “ ” means that the desired operation is not
permitted by the unit or disc.
Playing a Disc