SONIQ H10 - Manual (Page 13)

Troubleshooting
23
Problem
Power (LCD) is OFF
Power cord is not
well-connected
Please check the power cable
connection or power outlet
connection
Main fuse is out
Replace with the same
type and value fuse
Power (LCD) is ON
Volume is at ZERO
NO signal input
Check the function of
the sound source
Check the input selection and
switch to the proper input
Turn up the Volume
Sound Distortion High input signal level
Turn down the volume
to suitable position
Cause Remedy
Noise output
Sound field Positioning
is not so good
Signal input cables or
speaker cables are
wrongly connected
Reconnect it as suggested
in the manual
Ground of input signal cable
is open or bad contact of the
input signal cable
Components or circuits
are in trouble
Replace the input signal
cable with a new one
Please contact with local
agents or our company
NO Sound
Use the mute function
Cancel the mute function by
pressing“Mute” on the remote
control