SONIQ E46Z10A - Manual (Page 14)

Turning the TV on and off
1. Insert the power cord plug into a polarized AC outlet.
2. If TV is in standby mode Press POWER button on
the remote control or button on the bottom panel
of LED/LCD TV.
3. Normal picture will be displayed on the screen after 15 seconds. If no signal input,
"No Signal" will be displayed on the screen.
4. If temporary POWER off is required, press POWER button on the remote control or
button on the bottom panel.
5. If you want to completely switch off the power for this unit, unplug the power cord plug
for this unit.
6. After switching off the unit, you should
Status indication lamp
button is lighted: In standby mode.
Auto power-off
If there is no signal, the TV will 10 minutes.
Memory before turning TV off
wait at least 5 seconds before switching on again.
automatically enter standby mode after
See 'Auto sleep' pg. 34 for more details.
The picture and sound settings and preset channels will be memorised at the point when
the TV is turned off. When the TV is started up again it will work accordingly with these
settings.
1
How to turn the TV on or off
Basic Operation
Menu operation
1
Input Setup
Press INPUT key on the remote control to enter "INPUT
SOURCE" menu. There are twelve options for you to select:DTV,
ATV, AV1, AV2, AV3, Component, PC-RGB, HDMI1, HDMI2,
HDMI3, HDMI4 and USB Use ▲/qkey to move the cursor to
the input you desired and press OK key to confirm.
Channels Selection
There are four ways to select channel:
1) Using number keys, and OK keys on the remote control to
select channel directly. To select channel 90, press .
When you use the number buttons, you can directly select channels
that were either erased or not memorized.
2) Using PROGr/s key on the remote control or on your TV to select channel.
When you press the PROGr/s key, the TV changes channels in sequence. You will see all the
channels that the TV has memorized.
You will not see channels that were either erased or not memorized.
3) Press RECALL key to return to previous channel, press it again to return to current
channel.
To quickly switch between two channels that are far apart, tune to one channel, then use the
number keys to select the second channel. Then use the RECALL button to quickly alternate
between them.
RECALL is not activated if no channel has been changed after TV turning on.
4) Select channels from "Channel List" or "Favorite Channels List".
Press OK key to select Channel.
Volume Adjustment and Mute Setup
Volume adjustment
Press VOLr/s key on the remote control or on the TV to display "Volume" menu,
adjust the volume of TV between 0 to 100 by using VOLr/skey:
( To increase the volume, press VOLr key;
( To decrease the volume, press VOLs key;
Mute
Press MUTE and the sound cuts off. The MUTE icon will appear in the lower-left corner
of the screen.
To resume sound, press the MUTE button again, or simply press the VOLr/s key.
2
Basic Operation
3
9 0
Input Source
ATV
DTV
AV 1
AV 2
AV 3
Component
PC-RGB
HDMI1
HDMI2
HDMI4
HDMI3
USB
Select OK OK
-25- -26-