SONIQ E22Z10A - Manual (Page 27)

- 27 -
MAINTENANCE
Default
It takes 3-5 seconds to reset the unit to the factory default.
Parental Ctrl
DVDs are rated according to their content and some are equipped with a password function. The contents
allowed by parental lock level and the way a DVD is controlled may vary from disc to disc. For example, if
the disc allows, you could lockout violent scenes unsuitable for children or you could lock out playback of
the disc altogether.
You cannot play password function equipped DVDs rated higher than the level you selected unless
you cancel the parental lock function.
The parental lock levels are equivalent to the following ratings.
Level 1 : Kid Safe Level 5 : Pg r (M)
Level 2 : G Level 6 : R (MA 15+)
Level 3 : Pg Level 7 : Nc 17 (R)
Level 4 : Pg 13 Level 8 : Adult
CLEANING THE DISC
A defective or dirty disc inserted into the unit can cause sound to drop out during playback.
Handle the disc by holding its inner and outer edges.
• Do NOT touch the surface of the unlabeled side of the disc.
• Do NOT stick paper or tape on the surface of the disc.
• Do NOT expose the disc to direct sunlight or excessive heat.
• Clean the disc before playback. Wipe the disc from the center outward with a cleaning cloth.
• NEVER use solvents such as benzene or alcohol to clean the disc.
• Do NOT use irregular shape discs (example: heart shaped, octagonal, etc.). They may cause malfunctions.
CLEANING THE UNIT
• Be sure to turn the unit off and disconnect the AC power cord before cleaning the unit.
• Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth which has
been dipped in a weak soap-and-water solution and wrung out thoroughly. Then wipe it with a dry cloth.
• Never use alcohol, benzine, paint-thinner, cleaning fluid or other chemicals. Do NOT use compressed air
to remove dust.
IMPORTANT NOTE
Before shipping the unit, remove any disc from the disc compartment.
Password
Use or button to shift and select PASSWORD, use button to “Change”. Enter your 4-digit security
code until the cursor to OK. Press the ENTER/OK button.
If you forget the password, you can erase your current password by pressing number button
8 on the remote four times, then press the ENTER/OK button to confirm the setting
(PASSWORD : 8 8 8 8).
SYSTEM SETUP
1. Press the SETUP button.
2. Use the or button to select the System Setup, then press the
button to enter.
3. Use the or button to highlight the option ( Parental Ctrl, Password
or Default), then press the button to enter.
4. Use the or button to select the desired setup option.
5. To exit the SETUP MENU and return to the normal screen, highlight
the Exit Setup Mode ( ) and press the ENTER•OK button.
Parental Ctrl
Password ...
Default
1 Kid Safe
2 G
3 Pg
4 Pg 13
5 Pg r
6 R
7 Nc 1
8 Adult
CUSTOMIZING THE DVD FUNCTION SETTINGS