Soleus GPS Vibe (SG102) - Manual - Manual (Page 9)

Soleus Running – GPS Vibe
• The watch will take Auto Lap based on the Distance set in Auto Lap setting.
5.2.3. Press S5 to change the information displayed in Line 2. Following are the views
as your press S5:
• Information displayed in Line 2 will change as you press S5.
• Line 1 will display the Chrono or Split Time
• Line 2 will display the Lap time.
• Note: The watch will remember your previous screen view the next time you come back
to CHRONO mode.
5.2.4. How to view your current data before saving while the chronograph is stopped.
Following are the information as you press S5:
5.3) Using TIMER mode:
RUN mode & TIMER mode has the same chronograph counter. When the chronograph is
started or stopped in RUN mode, the same thing happens in TIMER mode.
•
The watch has 6 interval timers segment 1 to segment 6.
• The default values for all segments are 00:00:00.
• Please set the TIMERS first before using this mode.
• When you start the Chronograph in other modes like RUN mode, the set Timer
segments will also start counting down unless the timers are set to zero.
• When a segment reaches zero, there will be a 5 seconds beep sound and vibration
alarm. The watch will also display The Loop distance, Segment number, and the Loop
number for 5 seconds and continue counting down the next Timer segment.
• The cycle will loop for 50 loops and auto stop.
• If only 1 segment timer is set and the other segments are set to zero, only that segment
will countdown and loop up to 50 loops.
5.3.1. How to enter TIMER mode.