Revel Gem 2 - Manual (Page 18)

Ultima Gem2
Owner’s Manual
18
BI-WIRED CONNECTIONS
Bi-wired connections are made between both pairs of the Gem2
input terminals and one power amplifier output channel as
shown in Figure 7.
To make bi-wired connections:
1. Remove the jumper straps identified in Figure 4, page 11.
2. Connect one pair of loudspeaker wires to the high-frequency
of Gem2 input terminals. Then connect the same pair of
loudspeaker wires to the desired power amplifier output
channel.
3. Connect another pair of loudspeaker wires to the
low-frequency pair of Gem2 input terminals. Then connect
the loudspeakers to the same power amplifier output
channel that was selected in Step 2.
4. Make sure that all terminals are firmly hand-tightened.
Figure 7: Bi-Wired Connections
OUTPUT
POWER
AMPLIFIER
Gem2