Reloop DIGITAL JOCKEY - Manual (Page 50)

PVII: 1st audio device
In the preferences you can set your respective sound card.
PVIII / PIX / PX: 2nd audio device
If you have a sound card with at least four channels or a second sound card you
can select and enable it here . If you wish to adjust the latency for optimization
enable the “Device Parameter” -PIX- and adjust the latency via the knob -PX-.
NOTE!
Should you notice any clicking noise or if the music fails completely due to
low latency you must increase the latency via the knob -PX-.
PXI / PXII: 3rd audio device
Reloop Attack supports up to three sound cards. Check mark field -PXI- in order
to select and enable the third sound card -PXII-.
PXIII: Type
Here you can adjust your preferred and supported sound card routing. Please
refer to the following list:
PXIV / PXV / PXVI: Channel setting
Under the items -PXIV / PXV / PXVI- the preferences for the respective channels
for the mixed output, headphones and if necessary the right deck can be seleted.
PXVII / PXVIII / PXIX: Record device
With -PXVII- you can enable the input. In the preferences -PXVIII- select the
respective sound card input and under preferences -PXIX- the respective type.
Here it is possible to assign a microphone for example.
50
ENGLISH
2 channels mixed stereo output (standard)
4 channels 1 x mixed stereo output;
1 x stereo headphones output
4 channels (external) this type is used for the connection of an external mixer
and the internal equalizer and gain will be bypassed. 2 x
stereo output
6 channels 2 x mixed stereo output;
1 x stereo headphones output
2 channels x 2 1 x mixed stereo output and 1 x headphones output on 2
different sound cards
2 x channels x 2
(external) this type is used for the connection of an external mixer
and the internal equalizer and gain will be bypassed. 2 x
stero outputs on two different sound cards
2 channels x 3 2 x mixed stereo output on 2 sound cards;
1 x stereo headphones output on 3 different sound cards