RCBS APS Priming Tool - Manual (Page 12)

Next, tilt the strip loader away from
you until there is a primer in each
hole of the strip (you may need to
rock the tool to the left and right to
move the primers into position.) See
photo #23. Then tilt the tool towards
you to move all the extra primers
back away from the strip. Check to
confirm there is a primer in each
hole, but no extra primers are in the
strip area. See photo #24.
To seat the primers into the strip,
first read and then follow the steps
listed below. (Remember the dry run.)
• Be sure there is a primer in each
hole of the strip.
• Press down on the handle lever
(apply firm, even pressure). See
photo #25.
• Do not release the pressure on
the handle lever.
• Slowly raise the handle lever while
gently pushing on the right end of
the strip with the empty strip. See
photo #26.
• As the lever raises, you will be
able to push the strip through the
tool with the empty strip.
• Attach another empty strip to the
second strip as described above, and
repeat these steps. See photo #27.
12
Photo #23
Photo #24
Photo #25
Photo #26