Kino Flo Tegra 4Bank DMX (TEG-450) - Manual (Page 11)

11
DMX Channels
The Tegra 4Bank DMX operates on 1 or 4 DMX
addresses. On DMX Channel 1, one DMX address
controls/dims all 4 lamps on one dimmer channel.
On
DMX Channel 4, four DMX addresses control/dim
4 lamps individually.
Tegra 4Bank DMX
Address Sequence
(DMX Channel 4)
Lamp # DMX Address
Lamp 1 1
Lamp 2 2
Lamp 3 3
Lamp 4 4
Tegra 4Bank DMX Lamp Sequence
If a fixture loses its DMX signal, it will hold its last DMX command.
For this reason, it is important to turn a fixture off using the DMX commands.
For example, if you try to turn off the lights by turning off the dimmer board,
the lights will remember their last DMX command and stay on. The fixtures
require a DMX “Off” or “Black-Out” command in order to turn off.
Note: The Tegra ballast board incorporates a preheat circuit when striking
the lamps. Therefore, when fading up from black, there will be a 2-3 second
response delay. One way to avoid this issue is to lower the light level to
approximately 7-10% on the DMX console, then fade up from that point.